Drainage for Football Grounds in Heavy Rain Areas

In a region with long monsoons, drainage is the most important part of a ground. Here is how it works, what it is made of, and where mistakes happen.
Focus keyword: football ground drainage
Meta description: How to drain a football ground in heavy rain. Pipes, geotextile, stone and slope explained simply, from our Dhakuakhana stadium work in Assam.
Image alt: Perforated drainage pipe and stone layer being laid under a football ground

If you ask us the one thing that decides the life of a ground in Assam, we will say drainage. Not the turf brand, not the lights. The water.

We built the Dhakuakhana Football Stadium in Assam. Here is how drainage works on a ground, and what it is made from.

Why water is the real enemy

Rain does two kinds of harm. On the surface it makes the pitch slippery and unplayable. Underneath, it softens the soil, and once the soil is soft it moves. The sub-base sinks, the turf above it sinks, and you get dips that collect more water. It becomes a loop that only gets worse.

Good drainage breaks that loop by taking water away fast, both off the surface and out of the layers below.

Surface slope

First, the pitch itself is shaped with a very slight slope. Some pitches are crowned, higher in the middle and lower at the sides. Others slope from one end to the other. Either way, water has somewhere to go. The slope is too gentle to affect play, but enough to move water steadily.

Perforated pipes

Under the surface, we lay perforated pipes in trenches. The holes let water in. The pipes carry it to a collector drain at the edge of the ground, and from there into a pit, a drain or a natural channel. Pipes are laid at a slight fall so the flow keeps moving.

Pipe spacing depends on the soil. Heavy clay needs pipes closer together than sandy ground. [ADD: soil type on the Dhakuakhana site and how it affected the layout.]

Stone and geotextile

The trenches are filled with clean, washed stone with plenty of gaps between the pieces. Water moves through those gaps easily. The pipes and stone are wrapped in geotextile, a fabric that works like a filter. It lets water pass and holds back soil.

This fabric is cheap compared with the rest of the job. Without it, fine soil slowly clogs the stone and pipes. The pitch seems fine for two seasons and then starts holding water for no obvious reason.

Edge drains

Around the ground we build edge drains, small channels that catch the water running off the pitch and the stands. These must be big enough for peak rain, not average rain. We size them for the heaviest downpour the area is likely to see, and then keep a margin.

The outfall

A drain is only as good as where it ends. If the pipe empties into a spot that floods, the whole system backs up. We check where the water will go before finalising any design, including what the neighbouring land does in the monsoon.

Keeping drains working

Drains get blocked by leaves, silt and rubbish. We advise clients to clear the edge channels and inspection pits before every monsoon and after big storms. It takes an hour. A blocked outfall can flood a pitch that was built perfectly.

What to ask your contractor

Ask for a drainage drawing. Ask where the water will exit. Ask what fabric is being used. If the answers are vague, be careful.

You will find our other guides on this blog, and details of our ground-building work on the About page and Zajra Green.

Planning a ground, court or stadium?

Our team can visit your site and give you a clear plan and budget.

Visit Zajra Green

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top